![]() Valid_lft forever preferred_lft forever The rack mounted IDS sniffer. Link/ether 8e:e4:15:40:2b:50 brd ff:ff:ff:ff:ff:ffģ: dummy0: mtu 1500 qdisc noqueue state UNKNOWN group default qlen 1000 ![]() The setup can be verified using the ip commands:ģ: dummy0: mtu 1500 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000 # systemctl enable rviceĪfter a reboot to make sure all comes up as expected. Make sure systemd’s network config is enabled: (I’m getting link-local addresses after all, though. Try convincing it not to ask for IP addresses eg with DHCP: ![]() tzsp2pcap setup, the systemd wayįirst, make sure the dummy module is loaded at boot: However, with a more recent version of Raspberry Pi OS (also known as Raspbian) running systemd, the surrounding setup had to be done differently from last time. I’ve previously detailed how to build a receiver for this protocol, using the protocol bridge tzsp2pcap and the tcpreplay tool. MikroTik devices stream captured network traffic over a protocol named TaZmen Streaming Protocol.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |